Please use this identifier to cite or link to this item: http://repositorio.uisek.edu.ec/handle/123456789/4929
Title: Fabricación de un banco de pruebas para computadoras automotrices (ECM)
Authors: Llanes Cedeño, Edilberto Antonio
Ortega Carrillo, Wilson Alexander
Keywords: MECÁNICA AUTOMOTRIZ
ARDUINO
SIMULACIÓN
COMPUTADORA
SENSORES
Issue Date: Dec-2022
Publisher: Universidad Internacional Sek
Citation: CT-MAU O771f/2022
Abstract: En el presente proyecto se plantea desarrollar un banco de pruebas para ECM que cuente con un simulador de CKP y CMP mediante Arduino, el mismo que permitirá que la ECM funcione fuera del vehículo y de estar forma poder observar todas las señales tanto de entrada como de salida para los diferentes sensores y actuadores con los cuales cuenta un motor. En primera instancia se realizó una recopilación de todos los diferentes parámetros que permiten el funcionamiento de la ECM en el vehículo para que cuando la ECM este en el banco de pruebas esté en funcionamiento bajo las mismas condiciones que cuando está incorporada a un vehículo. De esta forma podremos observar y analizar todas las señales que van de la ECM a todos los diferentes sensores y actuadores incorporados, esto facilitara en gran medida el diagnóstico de la ECM así como también el aprendizaje de los estudiantes de la Universidad Internacional SEK en la carrera de Ingeniería Automotriz, ya que se podrá observar varias señales con un osciloscopio, señales que en un vehículo no se podrían observar por ubicación de la ECM. Además, que el banco de pruebas incorporada un conector OBD2, para poder conectar un scanner y observar todos los parámetros de funcionamiento de la ECM así como poder realizar una prueba de actuadores desde el mismo scanner.
Description: In the present project it is proposed to develop a test bench for ECM that has a CKP and CMP simulator using Arduino, the same that will allow the ECM to work outside the vehicle and thus be able to observe all the signals both input and output for the different sensors and actuators with which a motor has. In the first instance, a compilation of all the different parameters that allow the operation of the ECM in the vehicle was carried out so that when the ECM is on the test bench it is in operation under the same conditions as when it is incorporated into a vehicle. In this way we will be able to observe and analyze all the signals that go from the ECM to all the different sensors and built-in actuators, this will greatly facilitate the diagnosis of the ECM as well as the learning of the students of the SEK International University in the Automotive Engineering career, since it will be possible to observe several signals with an oscilloscope, signals that in a vehicle could not be observed by location of the ECM. In addition, the test bench has an OBD2 connector, to be able to connect a scanner and observe all the operating parameters of the ECM as well as to be able to perform an actuator test from the same scanner
URI: http://repositorio.uisek.edu.ec/handle/123456789/4929
Appears in Collections:Mecánica Automotriz

Files in This Item:
File Description SizeFormat 
Ortega Carrillo Wilson Alexander.pdf4.36 MBAdobe PDFView/Open


Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.